Setting up the BBPOS WisePOS E:
After unboxing your BBPOS WisePOS E, follow these steps to get everything setup:
Remove the battery cover
It is suggested to use something that won’t damage it, then lift up on the corner that has a small notch in the lower left when looking at it from behind. Keep lifting up until it comes off and be careful.
Place the battery inside and replace the battery cover
Power on by holding the power button on the right side for a few seconds
Plug in the charging cable, if needed, to power it up and charge the battery.
Connect to your network - WiFi or Ethernet (optional)
Connect to Wi-Fi
Wi-Fi with a Password is required
If you have an E-Dock, then plug in the ethernet cable on the underside and the power cord
Choose Language
Choose Country
The device will start updating software, this can take some time.
After the update is complete, a location needs to be created and the device needs to be registered.
Register the reader for DaySmart Recreation:
Add a location
Login to Stripe as an admin
Go to More or the Settings Gear in Stripe
Click on Terminal
Choose Get started.
From the dashboard go to Payments
Click on Readers
Choose Locations
Click the +New button
Name it and enter address
Click Save
Once the Setup has been completed, a Location ID will need to be sent to [email protected]. The location ID can be found within your Customer Stripe account.
Begin Registration
Login to Stripe as an admin
Click on Payments
Click on Readers
If Readers is not available, you can go to More or the Settings Gear in Stripe, click on Terminal, then choose Get started.
Click on the correct location where this device will be used
In the Readers section, click on the +Register Reader button
Enter the Registration Code that is showing on the WisePOS E screen.
If you no longer have the registration code screen appearing, swipe from the left side of the WisePOS E screen to the right side.
Press Settings
Enter the default PIN 07139
Press on Generate pairing code
Enter a unique Reader label
This is optional, but it is recommended.
Press Save
It might show Registration Successful, applying updates.
If it doesn’t, then on the WisePOS E screen, press Back, then Back again.